Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Malden?
Garage door work in Malden typically runs $150 – $600 for repairs, and the range covers most of what homeowners actually call about. A single spring repair is usually $180 – $340. A new door installation runs $700 – $2,200. Where your job lands depends on the part that failed, the door or opener brand, and whether the fix is a same-part swap or a system that needs adjusting in several places at once.
We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so the estimate reflects the equipment on your garage rather than a generic guess. Every number below is a typical estimate for the Malden market in 2026. The written estimate we hand you is what sets the final price.
Key Takeaways
- Most Malden repair calls fall between $150 and $600.
- Spring repair is $180 – $340 for one spring – a matched pair is usually replaced together and costs about twice that.
- Opener replacement runs $250 – $550 installed; repair of the existing opener runs $120 – $320.
- A full new door installation is $700 – $2,200 depending on size, material, and whether the old door and track come out.
- Free estimates and upfront pricing from start to finish – call (877) 367-9149.
Garage Door Cost Breakdown (2026)
Here are the typical estimated ranges for the work we handle most in Malden, broken out by job type. These are ranges, not fixed quotes; two houses on the same street can land at different points inside them.
| Job | Typical Estimated Range | What It Covers |
|---|---|---|
| Garage door repair (general) | $150 – $600 | The broad repair range for a door that won’t open, close, or sit level |
| Spring repair | $180 – $340 | Replacing one torsion or extension spring |
| Cable repair | $130 – $250 | Replacing a frayed or snapped lift cable and rebalancing the door |
| Opener repair | $120 – $320 | Fixing a belt, chain, logic board, remotes, or safety sensors on your existing opener |
| Opener installation | $250 – $550 | New opener supplied and installed, rail and hardware included |
| Panel replacement | $250 – $500 | Replacing dented or damaged door panels while keeping the frame |
| Track realignment | $120 – $240 | Straightening or resetting bent track so the door rides clean |
| Roller replacement | $110 – $220 | New rollers, which is the cheapest way to quiet a noisy door |
| New door installation | $700 – $2,200 | Full new door, track, hardware, and spring system |
What pushes a job toward the top of its range? A few things. A door that needs a whole new spring and cable system costs more than a single broken spring. Higher-end panel or door materials cost more than a basic steel build. Openers with smart-home features, camera systems, or battery backup carry a higher price than a straight replacement unit. And if the old door or track is rusted and seized, removal and re-fit adds labor. What keeps a job near the bottom? A one-part fix: a single roller set, one sensor realigned, one track nudged back into true.
A note on springs, because it’s the most misquoted job in the trade. The $180 – $340 figure is for one spring. Most doors carry two springs, and a matched pair is usually replaced together so the door stays balanced. A pair typically runs about twice that range. If a technician quotes a single price and won’t say whether it covers one spring or two, ask before the work starts.
What Affects Garage Door Pricing in Malden
Malden’s housing ranges from older two- and three-family homes to newer single-family builds, and the door on the garage reflects that mix. Here’s what moves your estimate, and it’s a short list, because garage doors are a small, fixed set of parts and the variables are predictable.
- Old or new door. An older wooden or steel door with worn springs and rollers needs more fiddling to bring back to spec than a recent install. Restoring an old door is still almost always cheaper than replacing it, but the labor climbs when parts are seized or out of alignment.
- Opener brand and era. LiftMaster and Chamberlain units, including newer Wi-Fi-enabled models, have widely available parts, so a repair is straightforward. A legacy Genie or Craftsman unit can need a bit more diagnosis when the logic board or a safety sensor has failed. We work on all of them and get the parts directly.
- Torsion versus extension springs. The high-tension torsion spring found on most modern doors takes more care to replace than an extension spring, which is why spring work sits at the higher end of the repair band. This is a job for a trained professional, not a homeowner with a wrench. A wound torsion spring stores enough force to injure someone badly, so we handle it as a specialty.
- Single-car versus double-car door. A wider door needs heavier springs, a larger opener, and more panel material, so it lands higher on both the repair and installation ranges.
- Panel damage vs. track damage. A dented panel is a $250 – $500 replacement. A bent track is a $120 – $240 realignment. When the two show up together, we price them as separate lines so you can see where the money is going.
- Whether the door needs a full replacement. When the panels, springs, and track are all past their useful life, repair costs stack up and a new door in the $700 – $2,200 range becomes the better call. We’ll tell you which one actually makes sense rather than pushing the bigger job.
Repair or Replace – What the Numbers Say
This is the question that decides the real budget, so it deserves its own section. Repair wins when the door itself is structurally sound and only one or two systems have failed. A new spring pair and fresh rollers on a door with good panels is cheap in the long run. Replacement wins when you’d be patching multiple failing systems at once – panels, springs, and track all going at the same time – or when the door is the wrong size or style and no amount of repair will make it fit right.
A rough rule we use on estimates: if the cost of repairing what’s wrong lands within about a third of the price of a new door, we’ll walk you through both instead of defaulting to the repair. That’s the part of the job a lot of companies skip. For a breakdown of what each repair option involves, our East Boston Garage Door Repair page covers the full service list.
How to Save on Garage Door Work in Malden
There’s no discount to unlock here, just a few ways to avoid paying for more than you need.
- Get an upfront estimate before any work begins. We give you a written range and the reasoning behind it, and the estimate is free. Call (877) 367-9149 and we’ll talk through the job before anyone touches the door.
- Fix a small fault before it grows. A noisy door with worn rollers ($110 – $220) often becomes a door with a stressed opener and a snapped spring if you wait. Roller replacement is the cheapest line item in the price list and the best preventive spend.
- Replace a matched spring pair, not a single spring. Replacing one spring of a pair saves a little now but leaves you with a door that’s out of balance and a second failure likely. Pair replacement is the cheaper move over time.
- Repair the opener if the door itself is fine. A $120 – $320 opener repair on a working door saves the $250 – $550 of a new opener and the labor of swapping one out.
- Source the parts yourself if it’s a small job. We supply garage door components directly, not just as part of a labor call, so a hands-on homeowner handling a simple swap can buy the part and skip the service charge.
Getting an Accurate Malden Estimate
The fastest way to a real number is a two-minute conversation. Tell us the door brand, roughly how old the door is, and what it’s doing – won’t open, moves unevenly, a loud bang from the springs, a remote that stopped working – and we’ll give you an estimated range before we schedule anything. Our technicians have up to 15 years of experience across the eight major brands, so they can tell a Genie opener fault from a LiftMaster sensor issue on the call and quote accordingly.
If you’ve narrowed the problem to one part and just want the component, we can point you to the right one or dispatch a technician. Either way, the written estimate sets the final price and you’ll know what you’re spending before work starts.
FAQs – Garage Door Cost in Malden
How much does garage door repair cost in Malden?
Garage door repair in Malden typically costs $150 – $600, with most single-part fixes landing near the lower end. A spring, cable, track, or roller issue is usually priced as its own line item. Call (877) 367-9149 for an exact quote – estimates are free.
How much does a garage door spring replacement cost in Malden?
Replacing one spring typically costs $180 – $340. A matched pair is usually replaced together and costs about twice that range. Spring work is the highest-risk repair in the trade, so we handle it as a specialty. Call (877) 367-9149 to book an estimate.
Is it cheaper to repair or replace my garage door in Malden?
Repair is usually cheaper when the door and panels are sound and only one or two systems have failed. Replacement makes more sense when panels, springs, and track are all failing at once, and a new door runs $700 – $2,200. We’ll tell you which one actually makes sense. Call (877) 367-9149 and we’ll walk through both.
How much does a new garage door opener cost installed in Malden?
A new opener installed typically costs $250 – $550, and repairing an existing opener runs $120 – $320. If your door itself is working fine, repair is almost always the cheaper call. Call (877) 367-9149 for a free estimate.
Can you come today if my garage door won’t open?
Same-day service is often available, so call and we’ll check. Fast dispatch runs from 7am to 7pm. Call (877) 367-9149 as soon as you notice the problem, and if the door is stuck partway open, keep people and vehicles clear of it until a technician arrives.
Talk to Us About Your Malden Garage Door
Whether the door needs a $110 roller set or a full $2,200 replacement, you’ll get a straight answer and an upfront price. We handle repair, opener repair, spring replacement, installation, and parts for whatever brand is on your garage – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor alike. Call (877) 367-9149 for a free estimate and we’ll get your Malden garage door working the way it should.
Pricing reflects the Malden market as of 2026. East Boston Garage Door Repair offers free estimates – call (877) 367-9149.
What Our Customers Say
"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Nathan Sullivan"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Erin Brooks"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Todd Bennett