Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Parts Across Everett
If you’re searching for garage door parts in Everett, you’re probably standing in front of a door that won’t close, a track that binds, or a spring that gave out. We supply and install the parts themselves – torsion and extension springs, cables and drums, rollers and hinges, weatherstripping and bottom seals – for whatever system is on your garage. Everett is a tight, built-out city, and we know these streets and these garages well enough to plan around the parking, the shared driveways, and the rear-lot clearances before we arrive. Call (877) 367-9149 for a free estimate.
Why Everett Homeowners Call East Boston Garage Door Repair for Garage Door Parts
We connect homeowners in Everett with local professionals who treat parts as the point, not an upsell. Plenty of companies will only sell you a part as part of a full labor call. We think a homeowner who wants to replace a single roller, a bottom seal, or a set of hinges should be able to source it and get honest guidance on whether it’s a job to tackle or hand off. That’s why parts supply is a service on its own with our garage door parts team.
We work on equipment from eight major brands and won’t turn a job away because of the nameplate. Our technicians have up to 15 years of experience, and they’ve seen the under-house garages and the back-lot boxes that make Everett different from a suburb full of wide driveways. When a door won’t shut, we diagnose the parts first and tell you plainly whether repair makes sense or a replacement does. No handoffs, no guessing, no steep invoice after the fact.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Parts Services in Everett
Torsion Spring
Most torsion spring failures in Everett come down to a spring that has simply run out of cycles on a low-headroom under-house garage. The spring carries the door’s whole weight, so when it lets go the opener is left straining against dead weight. A typical torsion spring repair in Everett runs $180 – $340 for one spring – a matched pair is normally replaced together and costs about twice that. This is the part to leave to a trained technician: the spring is under heavy tension and can cause serious injury if handled wrong.
Extension Spring
Some older Everett garages, particularly the small postwar capes, still run extension springs along the horizontal tracks. They age the same way, stretching and losing tension until the door drops fast. We replace extension springs and their safety cables so a broken spring stays contained rather than flying loose.
Cables & Drums
Cables and drums work with the springs, and on a narrow 8 – 9 ft opening a frayed cable will bind the door partway down. When a cable snaps, the door can hang crooked and jam, and it shouldn’t be forced. A typical cable repair in Everett runs $130 – $250, and we swap the drums and end bearing plates at the same time if they’re worn.
Rollers & Hinges
Road salt thrown off Route 1 and the Parkway eats steel rollers and hinges faster than you’d expect, and worn rollers make the whole door drag and rattle. A typical roller replacement in Everett runs $110 – $220, and a track realignment runs $120 – $240 if corrosion has knocked the tracks out of line. Replacing these parts is the cheapest way to quiet a door and stop it from binding.
Trusted Brands We Service in Everett
We work on LiftMaster, Chamberlain, Craftsman, and Raynor systems, along with the other major brands, so the name on your opener or door doesn’t limit your options. That matters in Everett, where a garage might carry a 1990s Craftsman opener next to a newer LiftMaster smart unit across the alley. We handle both legacy and modern app-connected openers, and we’ll tell you when a part will fix the problem versus when the unit itself has run its course. Parts are available directly – order the component or have a technician fit it. Same brand fluency, whether the door is original to the house or was swapped in later.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Parts Problems We See in Everett Homes
- Springs run out of cycles. An original torsion spring on a low-headroom under-house garage eventually exhausts its cycles, leaving the door dead-weight and the opener straining. A door that suddenly slams down is usually reporting the spring, not the motor.
- Salt and freeze-thaw corrosion. Road salt spray and ice dams at the door-to-apron seam eat through steel tracks, hinges, and bottom sections, so the door binds partway down. Corroded tracks throw off alignment and wear the rollers quickly.
- Rotted jambs and narrow openings. On 1930s – 50s two- and three-deckers, rotted wood jambs and 8 – 9 ft openings make bottom seal and weatherstripping a custom-fit job rather than a stock strip. A standard seal won’t sit right on a crooked or rotten jamb.
- Rear-lot clearance limits. On the dense streets off Broadway and near Glendale Park, garages sit at the back of the lot just inches from a shared line, so a door often can’t swing fully or take a ladder. Parts get replaced from the alley side or by pulling sections in place.
Pricing for Garage Door Parts in Everett, MA
These are typical estimated ranges for parts work in Everett, and the written estimate you get sets the final price. What moves a job up or down the range: access to the door, whether corroded bolts come free, whether a rear-lot clearance turns a simple swap into a section removal, and whether a part has to be special-ordered to fit an odd 1930s – 50s opening. We quote before any work starts, so you know the number going in. Here’s how the line items usually break down:
| Part Service (Everett) | Typical Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Roller Replacement | $110 – $220 |
| Track Realignment | $120 – $240 |
| Panel Replacement | $250 – $500 |
A matched pair of springs is usually replaced together and runs about twice the single-spring range. Call (877) 367-9149 for a free estimate on your specific door.
We Also Serve Cities Near Everett
The same parts service reaches the towns around us: Malden, Chelsea, Revere, and Charlestown. If you’re just over the line in one of those, the garage dimensions and climate are close cousins to what we see here, so the guidance holds. Give us a call and we’ll plan around the access on your street.
Serving Everett, MA – Our Local Coverage Area
We serve Everett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Parts in Everett
Yes. A torsion spring can be installed on a narrow, low-headroom door, but it’s a sizing job rather than a catalog match, and that’s exactly the situation most Everett garages are in. Narrow 8 – 9 ft openings and low headroom call for the right spring rating and mounting, which a technician measures on site. Spring work is under heavy tension, so this isn’t a DIY part. Call (877) 367-9149 for a free estimate.
Usually the opener is reporting a worn part, not failing itself. In Everett’s pre-1950 two- and three-deckers, a door that feels heavy and slams down is typically a torsion spring that’s run out its cycles, and the straining opener is just the messenger. We diagnose the parts first so you don’t replace a working opener. Call (877) 367-9149 for a free estimate.
Yes. Tight rear-lot clearance makes the job slower but not impossible. On the dense streets off Broadway and near Glendale Park, a garage often sits inches from a shared line, so a technician can’t swing the door fully or set a ladder – the work gets done from the alley side or by pulling sections in place to reach the drums, cables, and end bearing plates. Call (877) 367-9149 to talk through your access.
Road salt spray and coastal freeze-thaw are the culprits. Salt thrown off Route 1 and the Parkway settles on steel hinges and bottom sections, and ice dams at the door-to-apron seam start the rust from below. Swapping the corroded parts and fitting a proper bottom seal and weatherstripping slows it down. Call (877) 367-9149 for a free estimate.
Often just new remotes and a rolling-code setup solve the security question without a new unit. A modern rolling-code remote on your existing LiftMaster, Chamberlain, or Craftsman opener changes the signal each time, so a neighbor’s old remote or a code grabbed from the alley can’t open your door. If the opener is a legacy fixed-code unit and you’d rather upgrade, we’ll give you the real cost either way. Call (877) 367-9149 for a free estimate.
Whatever brand is on your garage, we’ll help you sort out which parts fit your building – not a generic catalog. Call (877) 367-9149 for a free estimate on garage door parts in Everett, with upfront pricing quoted and agreed before any work starts.
Written by the team at East Boston Garage Door Repair.